Introduction; Safety - Beha-Amprobe Telaris Série Guide D'utilisation

INTRODUCTION

The Amprobe Model Telaris ProInstall-100 and Telaris ProInstall-200 are battery powered
electrical installation testers. This manual applies to all models. All figures show the Model
Telaris ProInstall-200.
These testers are designed to measure and test the following:
• Voltage and Frequency
• Insulation Resistance (EN61557-2)
• Continuity (EN61557-4)
• Loop/Line Resistance (EN61557-3)
• Residual Current Devices (RCD) Tripping Time (EN61557-6)
• RCD Tripping Current (EN61557-6)
• Earth Resistance (EN61557-5)
• Phase Sequence (EN61557-7)
SYMBOLS

Caution! Risk of electric shock.
W
Caution! Refer to the explanation in this manual.
T
Double insulated (Class II) equipment
J
Earth (Ground).
I
Fuse.
Conforms to requirements of European Union and European Free Trade
P
Association.
Do not use in distribution systems with voltages higher than 550 V.
CAT III Testers are designed to protect against transients in fixedequipment
CAT III /
installations at the distribution level; CAT IV Testers are designed to protect
CAT IV
against transients from the primary supply level (overhead or underground
utility service).
Do not dispose this product as unsorted municipal waste. Contact aqualified
=
recycler.
SAFETY INFORMATION
A Warning identifies hazardous conditions and actions that could cause bodily harm or
death.
A Caution identifies conditions and actions that could damage the tester or cause
permanent loss of data.
Warnings: Read Before Using
W
To prevent possible electrical shock, fire, or personal injury:
• Do not use in CAT III or CAT IV environments without the protective cap installed. The
protective cap decreases the possibility of arc flash caused by short circuits.
3