Electrical Measurement Specifications; Continuity (Rlo) - Beha-Amprobe Telaris Série Guide D'utilisation

Battery life (typical)
Fuse
Operating Temperature
Relative Humidity
Operating Altitude
Sealing
EMC
Safety
Pollution Degree
Maximum voltage between
any terminal and earth ground

Electrical Measurement Specifications

The accuracy specification is defined as ±(% reading +digit counts) at 23 °C ±5 °C, ≤80 %
RH. Between -10 °C and 18 °C and between 28 °C and 40 °C, accuracy specifications may
degrade by 0,1 x (accuracy specification) per °C. The following tables can be used for the
determination of maximum or minimum display values considering maximum instrument
operating uncertainty per EN61557-1, 5.2.4.
Electrical Measurement Specifications
Range
500 V
Continuity Testing (R
Range
(Autoranging)
20 Ω
200 Ω
2000 Ω
Note: The number of possible continuity tests with a fresh set of batteries is 2500.
200 hours idling
T3.15 A, 500 V, 1.5 kA 6.3 x 32 mm
0 °C to 40 °C
80% 10 to 30°C; 70% 30 to 40°C
0 to 2000 meters
IP 40
Complies with EN61326-1: 2006
Complies with EN61010-1 Ed 3.
Complies with EN/IEC 61010-031:2002+A1:2008.
Overvoltage Category: 500 V/CAT III
300 V/CAT IV
Measurement Category III is for measurements
performed in the building installation. Examples are
distribution panels, circuit breakers, wiring and cabling.
Category IV equipment is designed to protect against
transients from the primary supply level, such as an
electrical meter or an overhead or underground utility
service.
Performance EN61557-1, EN61557-2, EN61557-3,
EN61557-4, EN61557-5, EN61557-6, EN61557-7 Second
edition. EN61557-10 First edition.
2
500 V
Resolution Accuracy
50 Hz – 60 Hz
0.1 V 2% + 3digits
)
LO
Resolution
0.01 Ω
0.1 Ω
1 Ω
Input Impedance Overload
3.3 MΩ
Open Circuit Voltage
>4 V
>4 V
>4 V
25
Protection
660 V rms
Accuracy
±(3 % + 3 digits)
±(3 % + 3 digits)
±(3 % + 3 digits)