Uploading Test Results; Maintaining The Tester; Cleaning; Testing And Replacing The Batteries - Beha-Amprobe Telaris Série Guide D'utilisation

Uploading Test Results

IR Adapter
To upload test results:
1. Connect the IR serial cable to the serial port on the PC.
2. Attach the IR adapter and the device to the tester as shown in Figure 23.
3. Start the Amprobe PC software program.
4. Press to turn on the tester.
5. Refer to the software documentation for complete instructions on how to upload data
from the tester.

MAINTAINING THE TESTER

Calibration
To ensure the accuracy of the measurements it is recommended that the instrument is
calibrated regularly by our service. We suggest a calibration interval of one year.

Cleaning

Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or
solvents.
Dirt or moisture in the terminals can affect readings.
To clean the terminals:
1. Turn the meter off and remove all test leads.
2. Shake out any dirt that may be in the terminals.
3. Soak a new swab with alcohol. Work the swab around each terminal.

Testing and Replacing the Batteries

Battery voltage is continuously monitored by the tester. If the voltage falls below 6.0 V (1.0
V/cell), the low battery icon
battery life left. The low battery icon continues to appear on the display until you replace
the batteries.
Figure 23. Attaching the IR Adapter
appears on the display, indicating that there is minimal
22
IR Device