Carry Handle Assembly - RIDGID HD06000 Mode D'emploi

SP7030-1 HD06000 HD09000 2018.qxp_HD0600 HD0900 3/7/18 1:55 PM Page 7
ASSEMBLY

Carry Handle Assembly

1. Locate the Carry Handle and the two (2)
#10 x 3/4" Pan Head Screws in loose
parts bag.
2. Position the Carry Handle on top of the
Powerhead Assembly, with the Carry
Handle Extended Flange to the rear of
the Powerhead, as shown.
3. Insert a #10 x 3/4" Pan Head Screw
through the hole at each end of the
Carry Handle and into the Powerhead
Assembly. Tighten securely.
Extended
Flange
Inserting the Tug-A-Long
Positive Locking Hose with
Dual-Flex
1. Insert the larger end of the Tug-A-Long
2. To remove the Tug-A-Long Positive
#10 x 3/4" Pan
Head Screws (2)
Carry Handle
Powerhead
Assembly
7
Positive Locking Hose with Dual-Flex
into the Inlet Port. Engage the Hose
Latch to the lip of the Inlet Port.
The Hose should snap into place.
Locking Hose with Dual-Flex from the
Vac, press the Release Button on the
Hose and pull the Hose out of the Inlet
Port, as shown.
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Powerhead
Assembly
Vac Inlet
Release
Button