Operation; Integrated Dust Extraction With Microfilter; Empty The Dust Box; Replacing The Sanding Sheet - TOOLCRAFT T-MS 200 W Notice D'emploi

7. Operation

Read the instruction book carefully. Make sure that all the products' packaging has been removed. Ensure
that the voltage indicated on the rating label matches the main voltage before plugging in the appliance.
a) Integrated dust extraction with microfilter
• See figure A.
• Always use the appliance with the dust box (2) connected, inhaling dust
is harmful to your health.
• Connect the dust box (2) to the filter connector (5)
b) Empty the dust box
• See figures C, D and E.
• To empty the dust box, pull off the dust box (2)
• Remove the filter lid (6) pulling it as it is shown in fig D.
• Remove the filter element (7) from the dust tank (8).
• Clean the filter element (7) and the dust tank (8) with a soft brush.
c) Replacing the sanding sheet
• See figure B.
• To remove the sanding sheet (3), grasp it at one of the tips and pull it off
from the sanding plate (4).
• Pay attention that punched holes of the abrasive sheet (3) match with
the holes of the sanding plate (4).
• Position the sanding sheet (3) flush alongside one edge of the sanding
plate (4).
• Lay the sanding sheet onto the sanding plate and press firmly.
• To remove the sanding sheet (3), grasp it at one of the tips and pull it off
from the sanding plate (4).
d) Switch on and switch off
• See figure A.
• To start the tool, press the on/off switch to "I" ON position (1).
• To stop the tool, press the switch to "O" OFF position (1).
24
Fig.B
Fig.C
6
8
Fig. D
Fig. E
8
3
2
7