Temperature Levels; Automatic Switch-Off; Cleaning And Care - SilverCrest SRNH 100 E3 Instructions D'utilisation Et Consignes De Sécurité

Start-up / Cleaning and care
Switching off:
Set the control unit
heating pad.
Note: The operating display
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
ting the heating pad for several hours,
we commend setting the control unit
to the lowest setting to prevent
1
overheating and potential burns to
the part of the body heat is applied
to.

Temperature levels

Set the required temperature level on the con-
trol unit (see fig. A).
1
Level 0: off
Level 1: minimum heat
Level 2–5: customised heat
Level 6: maximum heat

Automatic switch-off

Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
Then select the setting 0 and after about 5 se-
conds, reset the heating pad to the desired
temperature setting to switch it on again.
10 GB/IE/NI
to 0 to switch off the
1
will switch off.
2
When opera-
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (setting 0),
– unplug from the socket,
– disconnect the plug-in connection
control unit , from the heating pad.
1

Cleaning and care

LIfe BY eLeCTRIC SHOCk! Always
remove the mains plug from the socket
and the plug-in connector
unit from the heating pad (see fig. B) before
1
cleaning the heating pad. Otherwise there is a
risk of electric shock.
Use a dry, lint-free cloth for control unit
ning and care.
RISk Of DAMAGe TO THe PRO-
DuCT OR PROPeRTY! Never im-
merse the control unit
other liquids. It may otherwise be damaged.
If the heating pad is slightly soiled, use a dam-
pened cloth and a little liquid mild detergent, if
necessary.
RISk Of DAMAGe TO THe
PRODuCT OR PROPeRTY! Do
not use chemical cleaning or scouring
agents to clean the heating pad and control unit
. The heating pad and control unit
1
otherwise be damaged.
The heating pad is machine-washable.
Set the washing machine at an extra
washing cycle for delicate items at
30 °C.
For ecological reasons, please only wash the
heating pad together with other textiles. Use a
mild laundry detergent according to the
2
manufacturer's instructions.
Please note that frequent washing will cause
wear to the heating pad. It should therefore be
washed no more than max. 10 times in a washing
machine throughout its useful life.
RISk Of DAMAGe TO THe
PRODuCT OR PROPeRTY! Please
note that the heating pad may not
, i.e. the
3
DANGeR TO
with the control
3
clea-
1
in water or
1
may
1