Guide Bar And Saw Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 435 II Manuel D'utilisation

Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna chain saw model 440. This chain saw model
equipped with either of the listed bar and saw chain combination(s), fulfills the requirements according to ANSI B175.1-
2000 (Gasoline Powered Chain Saws - Safety Requirements).
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw model Husqvarna 440 met the kickback performance requirements of ANSI B175.1-2000 when tested with
the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a low kickback
saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2000. We recommend to
use only the listed combinations of bars and chains for chain saw model Husqvarna 440. Other chain saw models may
not meet the kickback requirements when equipped with the listed guide bar and saw chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chainsaw model 440. The listed combination(s)
of powerhead, bar and saw chain meet all requirements outlined in Canadian Standards Assosiation Z62.1-03 (Chain
Saws) and Z62.3-04 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H30 is evaluated and listed as a Type C Low Kickback Saw Chain according to
the provisions in Z62.3-04.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.

Guide bar and saw chain combinations

Length, inch Pitch, inch
16
0.325
18
Saw chain filing and file gauges
1154886-49 Rev.6 2014-12-03
TECHNICAL DATA
Guide bar
Thickness of drive
links, inch/mm
0.050
Max. nose radius Type
10T Husqvarna H30
Saw chain
Drive link count
66
72
English – 33