Start Here - Petsafe Simply Clean Manuel D'utilisation

Start Here

NOTE
The litter guard and conveyor cover must be installed correctly for unit to operate properly.
If not installed correctly, litter guard can lift up conveyor cover and cause a power outage. Safety
features require that these pieces are installed correctly so moving conveyor is not exposed.
1
1. Remove the Simply Clean
components from packaging. Place the litter box on a
firm, flat surface. Remove thumb screws from center of
the litter bowl and top of the conveyor.
3
3. Slide the wide end of the litter guard under the
conveyor, aligning the square hole on the conveyor with
the square post on the litter guard.
Automatic Litter Box and
®
www.petsafe.net
2
2. Lift the conveyor to its upright position. Attach the litter
guard to the litter bowl by first placing the tab at the
narrow end of the guard under the bowl lip. Attach the
two vertical clips on the guard under the bowl lip.
4
4. Lower the conveyor making sure the waste guide is in
position, and reinstall the screws.
5 5