EUROM Sani Wallheat 2000 Wifi Manuel D'utilisation page 35

Description
Heater
1. Main switch
2. Blow out grid
3. Connection for external
temperature sensor
4. Display
5. Suction grids (rear
side)
Remote control
A. ON/OFF button
B. Function selection button (MODE)
C. Swing
D. Higher temperature
E. Lower temperature
Display:
a. Temperature light
b. Heating light (half capacity)
c. Heating light (full capacity)
d. WiFi light
e. Function selection button (MODE)
f. Oscillate/swing light
g. Temperature and WiFi button
h. Fan light
The remote control operates on a cell battery, type CR2025 (3V).
 The heater must hang on a wall and must not be used lying down, leaning or
standing!
 The heater should preferably be installed near or over an electric
connection point and should be connected permanently. Only a certified
electrician is allowed to carry out this connection and therefore it is not
35