Attaching The Speakers To The Brackets - Bose 251 Notice D'utilisation

Installing Your 251
Installing the mounting brackets (cont.)
Figure 10
Installing the bracket onto a deck
railing or table

Attaching the speakers to the brackets

Figure 11
Installing the knobs
Figure 12
Sliding the speakers into the
brackets
8
Speakers
TM
Installing the brackets onto a deck railing or table (cont.)
Finally, install the four screws using a Phillips-head screwdriver (Figure 10).
Note: If you are mounting your 251
Bose logo. Refer to "Rotating the Bose logo" on page 11 for instructions on how to do this.
Once the brackets are installed, carefully follow these steps to attach the speakers to the
brackets. First, insert the knobs into each side of the speakers. Be sure to turn each knob two
full rotations (Figure 11). Then, carefully slide the speakers into the brackets (Figure 12). Finally,
temporarily tighten the speaker in a position that will allow you to easily connect the speaker
wire (Figures 13A and 13B).
speakers on a deck railing or table, you will need to rotate the
TM
two full rotations