Using The Steam Generator - Domo DO7102S Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
www.domo-elektro.be
This is normal. This noise means that water is being pumped to the sole plate.
While the soleplate is heating up, some steam will be released automatically. This
is also normal and will last for about 3 seconds.

USING THE STEAM GENERATOR

This steam generator offers 2 options: dry ironing or steam ironing. Follow the
instructions below. Also carefully read the ironing tips at the end of this section before
using the appliance.
Dry ironing
1. Place the iron on the thermal insulation pads of the steam generator.
2. Plug in the appliance.
3. Select the desired temperature with the temperature dial, according to the kind of
fabric that needs to be ironed. The temperature indicator will light up and the iron
will start heating up.
4. When the temperature indicator goes out, the selected temperature has been
reached. You can now start ironing.
Caution: Never touch the hot soleplate!
Steam ironing
Caution: do not plug in the appliance yet at this point.
1. Grasp the water reservoir from the steam generator by its handle and press the
button to remove the water reservoir from the generator. Open the cover of the
filler opening and fill the reservoir with water. Use demineralised water for this.
Make sure you do not exceed the maximum level (1.8 l). Close the filler opening
after filling.
2. Replace the water reservoir back in the steam generator. Caution: if the reservoir
is not replaced properly, the machine will not produce any steam.
3. Place the iron on the thermal isolation cushions of the steam generator.
4. Put the plug in the mains. Set the temperature disc at the desired temperature,
depending on the type of material, and the temperature light will light up.
5. The water in the water reservoir will heat up and after a few minutes the
temperature light will go out. This means that the steam generator has reached the
correct temperature. You can now press the steam
button to discharge steam.
Caution: the temperature button must be in the
steam area for this (indicated by
Between ironing, the iron may be placed on the
base for a short while.
Please note:
Do not touch the hot sole of the iron!
Never aim steam at people!
).
47
DO7102S-DO7103S

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Do7103s

Table des Matières