MZ electronic EVV-A Instructions D'utilisation page 14

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Installing the EVV-A
(see connection diagram)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO
INSTALLATION.
The instrument must be positioned so that the display will be easy to read. It should
not be exposed to direct sunlight.
The rear part of the instrument must be protected from contact with water or moisture.
The instrument may be fastened to dashboards of any thickness. The screws used
for clamping must be of the self-threaded kind and with a diameter of 2.9 mm (~1/8")
and a maximum length of 10 mm plus the thickness of the dashboard.
In the part to the rear of the dashboard there must be minimum clearance of 35 mm
(1" 3/8) and there must also be adequate access to perform installation and
maintenance work.
Apply the hole template on the dashboard (see appendix) and make a hole with a
diameter of 25 mm (~ 1") in the centre, as indicated, and 2 holes with diameters of 3.2
mm (~1/8") for the Voltmeter-ammeter clamping screws. Use
cutting nippers to cut the three pins on the back of
the instrument, position the Voltmeter-ammeter and
fasten it to the dashboard by tightening the two screws. If
the dashboard already has a hole with a 54 mm
(2"1/8) diameter, it is not necessary to cut the
pins on the back.
EVV-A
14
English
Rev. 03 – 2008

Publicité

Table des Matières
loading

Table des Matières