System Requirements; English - i-tec U3HDMIDVIDOCK Mode D'emploi

USB 3.0 Dual Docking Station
INTRODUCTION
Thank you for purchasing the i-tec docking station that will allow you to connect your
favorite pieces of hardware such as a keyboard, mouse, external disk or USB printer
through the USB ports, audio system through the input for earphones and microphone,
internet modem / LAN Ethernet PC network through the LAN port, monitor through the
DVI-I and HDMI port, etc. to your notebook / tablet / PC. You can connect all of these
pieces of hardware easily and fast to your notebook / tablet / PC by a single USB 3.0
cable. You can display your data on modern LCD and plasma monitors and TV sets
because the docking station is equipped with a DVI-I and HDMI port. The graphic chip
which makes the "heart" of the docking station supports even the Full HD+ resolution
(2048 x 1152 pixels). Each of the six USB ports (1x USB 3.0 Fast, 1x USB 3.0 and 4x USB
2.0) can be used for charging but only the port marked USB 3.0 Fast has a function in
accordance with the BC 1.2 specification (for charging of the iPad or Samsung tablets).
Another advantage is that the docking station can be used either in a vertical or a
horizontal position.
CONTENT OF THE PACKAGE
• i-tec USB 3.0 docking station
• Base plate
• Power adapter
• USB 3.0 cable (one end connector type A, the second end type B; 100 cm)
– for connecting to a notebook / PC
• Quick Start
External power supply exclusively for use with U3HDMIDVIDOCK.

SYSTEM REQUIREMENTS

• Hardware requirements: notebook / tablet / PC with a free port USB 3.0 / 2.0. If you
have USB 2.0, the data transfer speed will be reduced. Processor Intel Pentium 1.2
GHz and higher, 512 MB RAM.
• Operating system: Windows 7 / 8 / 8.1 / 10 32/64 bit, macOS X, Linux Ubuntu 14.04,
16.04, 17.10, Android 5 (Lollipop) a higher
• For playing a DVD on an additional monitor the processor shall be at least Intel
Pentium 2.0 and higher, 1 GB RAM and a screen resolution shall be 800x600 and
16 colors.
CAUTION!
Charging: The docking station supports charging of the connected USB mobile
equipment such as smartphones, ebook readers, multimedia players, GPS navigations
and tablets (e.g. Asus, Toshiba, Dell, GoClever, Prestigio, Emgeton, Sencor). Simply
connect the equipment you want to charge using the original cable to the USB port of the
docking station with the connected power adaptor. The only exceptions are the Apple or
Samsung tablets which are supported as well but only on the USB 3.0 Fast port with the
BC 1.2 specification. At the same time the docking station must be disconnected from
the computer/notebook and the inclosed power adaptor must be connected.
USB 3.0: Before the installation on the USB 3.0 port make sure that you have the most
recent drivers installed for this port (for the USB 3.0 controller into notebook / tablet /
PC). Products with the USB 3.0 SuperSpeed technology have been used since 2010;
however, the drivers for the supported equipment are still undergoing some fine tuning.
Your notebook / tablet / PC needs to be equipped with the USB 3.0 interface so that you
can utilize the advantages of the fast USB 3.0 equipment. Its problem free function is
ensured by the chipset which needs to have the current drivers available.
4 |

ENGLISH