Siebert S102 Série Manuel D'utilisation page 26

Step size
To be able to clearly read off the lowest digit even if the measurement signals are
changing rapidly or with large scale values, the step size can be augmented in menu
item 4.
With setting 5, digit C1 still only displays the digits 0 and 5. With setting 10, it displays
an unchanging zero.
With setting 50, digit C1 displays an unchanging zero, and digit C2 still only displays
the digits 0 and 5. With setting 100, digits C2 and C1 display an unchanging zero.
Averaging
The analog-to-digital converter has an integration time of 0,25 s, allowing the
measurement of rapidly changing values. In the case of strongly interfering
measurement signals it can be useful to display an average value formed over
several integration intervals.
With setting 1 in menu item 5, an average is not calculated for several averaging
periods. With setting 2, 4 or 8, an average is calculated for 2, 4 or 8 averaging
periods.
Switching outputs
The devices have two switching outputs with zero-voltage NO outputs (output 1:
CO1, NO1; output 2: CO2, NO2). The switch levels of the outputs can be set in menu
items 6 and 7.
The number of the menu item and the current setting appear in turns under menu
item 6 (output 1) or 7 (output 1). At the same time, the decimal points flash in turns.
The digit in which the decimal point flashes can be set to the desired value by using
the menu button [ ]. The minus sign can be set in the left digit. It appears between 9
and 0.
The relays are activated as soon as the measured value is the same or greater than
the switching point set in the menu. They are deactivated as soon as the measured
value undershoots the set switching point by the hysteresis set in menu item 8.
The actual display value is compared. A decimal point set in menu item A is not
considered.
In menu mode, the switching functions are not defined.
26 BAL S102 ANA M 1.0