Siebert S102 Série Manuel D'utilisation page 25

Features
Brillant LED display
Bipolar signal inputs ±20 mA / ±10 V
Completely scaleable display range
Programmable increments and averaging
Two programmable switching outputs with zero-voltage contacts
Wire-break detection
Serial signal output
Hold input
Parameterization via menu
Plug-in screw terminal strip
Signal input
The units must be parameterized before they can be controlled. Parameterization
occurs in a menu (see 'Parameterization').
The units can be controlled with the normalized signals 0...20 mA, 4...20 mA,
0... 10 V and 2...10 V. In menu item 1 the input signals with which control is to be
carried out are set.
The power supply as well as the analog inputs are galvanically isolated from the
internal signal processing.
Display range
Start and end value of the display area can be set in the menu items 2 and 3.
The number of the menu item and the current setting appear in turns under menu
item 2 (start value) and 3 (end value). At the same time, the decimal points flash in
turns. The digit in which the decimal point flashes can be set to the desired value by
using the menu button [ ]. The minus sign can be set in the left digit. It appears
between 9 and 0.
o (overflow) will be indicated in case of a display overrange and u (underflow) in
case of a display underrange.
BAL S102 ANA M 1.0 25