DeWalt DWX723 Guide D'utilisation page 3

Definitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and pay
attention to these symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D WALT TOOL, CALL US TOLL FREE AT: 1-800-4-D
E
(1-800-433-9258)
Miter Saw Stand with Folding Legs
DWX723/DWX724
This stand is designed for use with most miter saws. If you have
any problem with alignment or mounting, call 1-800-4-D
(1-800-433-9258).
WARNING: For your own safety, read the miter saw
instruction manual before using any accessory. Failure
to heed these warnings may result in personal injury and
serious damage to the miter saw and the accessory. When
servicing this tool, use only identical replacement parts.
Carton Contents
1 Miter saw stand (DWX723 or DWX724)
2 Miter saw mounting brackets (DW7231)
2 Work piece support and length stops (DW7232)
1 Hardware bag
Tools Required
• Drill with 3/8" (9.5 mm) drill bit (Not required for D
Saws)
• Crosshead #2 screwdriver
• 1/2" (13 mm) Wrench
Components (Fig. 1)
WARNING: Never modify the stand or any part of it. Damage or
personal injury could result.
Refer to Figure 1 for Components List.
General Safety Instructions for Miter Saw
WALT
E
Stands
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
wear eye protection that conforms to ANSI Z87.1.
• ALWAYS check the stability of the miter saw stand and the miter
WALT
E
saw attached to it before putting the stand or the saw into use.
• DO NOT mount any power tool other than a miter saw to this
stand. Mounting other power tools to this stand could result in
severe personal injury.
• DO NOT exceed the weight this stand can hold. The main center
beam of the miter saw stand is designed to support 500 lbs.
(227 kg.) safely in a work environment. It is unsafe to climb, sit or
stand on the stand.
1
WALT Miter
E