ResMed Swift FX Nano Mode D'emploi page 13

Reprocessing the mask between patients
This mask should be reprocessed when used between patients.
Cleaning, disinfection and sterilisation instructions are available from
the ResMed website, www.resmed.com/masks/sterilization. If you
do not have internet access, please contact your ResMed
representative.
Troubleshooting
Problem/possible cause
Mask is too noisy.
Vent is blocked or partially
blocked.
Elbow inserted incorrectly.
Mask is leaking.
6
Solution
If the vent requires cleaning, use a soft
bristle brush.
Remove the elbow from the mask and
then reassemble according to the
instructions.
Ensure that the swivel ring on the elbow
has not been inserted too far into the
cushion.
Refit or reposition your mask.
Readjust the back strap to bring the mask
closer to the face and improve your seal.
Check that your mask is assembled
correctly.