Panel Installation - Daikin FWG05AATNMV1 Manuel D'installation

8. Panel Installation

• The front panel can only be fitted in one direction, follow the piping direction. (Follow piping arrow sticker on front panel)
• Be sure to remove the installation template before installing the front panel.
• Open the air intake grille by pulling back the catchers and removing it together with filter from panel.
• Install the front frame panel onto the indoor unit by 4 screws and tighten it completely to prevent cool air leakage.
• Connect the LED wire and air swing wire to the indoor unit.
• The air swing connector must put inside the control box after connected.
NOTE
Install the front frame panel firmly to prevent cool air leakage which will cause condensation and water dripping.
1 IM-CKEW(DC)-1013(1)DAIKIN-EN.i6 6 1 IM-CKEW(DC)-1013(1)DAIKIN-EN.i6 6
Open
LED Wire
From Front
Panel
Air Swing Wire
Indoor Unit
Cool
Air
Ceiling Board
Panel
From Unit
Control Box
Cool
Air
Air Leak
1-6
Screw
Air Leak
Ceiling Board
Panel
7/1/14 2:39:05 PM 7/1/14 2:39:05 PM