Systeem Setup - Alecto DVM-700 Mode D'emploi

Cry alert: (VOX function)
You may continuously watch/listen to your baby or only when the baby is crying
as follows:
Watch/listen continuously:
1a
1. touch the screen in a random spot, touch Menu and then touch Cry Alerts
2. now touch VOX sensitivity and select Off
Press the Home button to exit the menu and to return to the standard display. The
video and audio are now active at all times.
You can still enable or disable the video by pressing the Screen On/Off button
and you may adjust the volume level using the – Vol. + button
VOX controlled watching/listening:
1a
1. touch the screen in a random spot, touch Menu and then touch Cry Alerts
2. now touch VOX sensitivity and select Low, Med or High
Press the Home button to exit the menu and to return to the standard display.
Operation:
• When the baby is sleeping quietly, the video and audio will be switched off
(you can always enable the video/audio by briefly pressing the Screen On/Off
button; the video and audio will be switched off again after several seconds)
• As soon as the baby starts crying, the video will be switched on. Provided the
volume isn't set to level 0, the audio will be switched on as well so you can see
and hear your baby. After the baby goes back to sleep again, it'll take 10 to 15
seconds until both video and audio switch off.
• If the volume is set to level 0 but the baby is making little noise, only the
display will switch on. If the baby is crying loudly (so loud that also the red
lights on the left side of the display are illuminated, see paragraph 2.4, item 7),
the display will switch on while you also get the 'Cry Alert' warning.
1 1c
b
1 1c
b
• This 'Cry Alert' warning consists of a warning in the display and you may also
set the following (see the tab 'Cry Alerts'):
1. Beep & Vibrate: beep tone + vibration
as an extra warning
Vibrate: only vibration as an extra
warning
Beep: only a beep tone as an extra
warning
Screen only: only a warning in the
display
2. This setting has no function
• example of a warning when the baby is crying:
- the alert stops automatically after 30
seconds or you may press 'Dismiss' to stop
the alert beforehand
- touch 'Settings' to open the menu directly
and then set the alarm
To set the level at which the video and audio of the receiver are enabled again, go
to the tab Menu – Cry Alerts – VOX Sensitivity.
Off: VOX disabled, video and audio are transmitted continuously
Low: low sensitivity, the bay must be crying loudly before the receiver is switched on
Mid: average sensitivity, the receiver is switched on when they baby is crying
normally
High: high sensitivity, the receiver is switched on even when the baby is crying softly

4.6 SYSTEEM SETUP:

You may use the touch-screen of the parent unit to adjust the system settings of
the baby monitor.
1a
1. touch the screen in a random spot, touch Menu and then touch Settings
44
1
2
1b 1c