Installation; Parent Unit - Alecto DVM-700 Mode D'emploi

3

INSTALLATION

3.1 BABY UNIT: (CAMERA)
The baby unit is not waterproof and thus only suitable for indoor use.
Power adaptor:
1. Connect one of the supplied
power adaptors with the
input at the rear of the baby
unit.
2. Insert the adaptor into a 230V
wall socket.
Only use the supplied power adaptor.
Make sure the baby cannot touch the
cable. Place the baby unit at least 1 to 2
metres away from the baby and bundle excessive
cable length with tape or cable-ties available
specifically for this purpose.
Table model or wall model:
You can place the baby unit on a table, cabinet or desk or you can mount it onto
a wall.
Wall-mounting:
Drill two holes in the wall, next to each other at a distance of 3.7 cm from each
other, and insert plugs and screws. Make sure to let the screws protrude for
several millimetres.
Suspend the baby unit by sliding the cut-outs in the camera support over the
screws and pressing the baby unit somewhat downward. Finally, neatly tuck away
the adaptor cable with cable-ties.
Placement tips:
• When used as a baby phone: place the baby unit at least 1-2 metres away
from your baby and make sure to safely tuck away the adaptor cable.
• It's recommended to place the baby unit as high as possible and away from
large metal surfaces; this ensures an optimal range.
• Don't connect the adaptor cable at the rear too tight. Allow for sufficient cable
length to ensure that the camera won't be impeded when moving.

3.2 PARENT UNIT:

The Parent unit is not waterproof and thus only suitable for indoor use.
Power supply:
The parent unit may be powered directly by the supplied
rechargeable battery. This battery is already installed
during the manufacturing process. Pull the insulating strip
out of the parent unit to activate this battery.
This battery is recharged by connecting one
of the supplied power adaptors directly to the
parent unit.
1-2 meter
Charging :
As soon as the power adaptor is connected to the unit and a 230V wall socket, the
battery will be charged.
• When using the unit for the first time, please charge the battery for at least 15
hours regardless of the indicator showing a fully charged battery.
• The charging circuit of the battery is controlled electronically. You may leave
the parent unit onto the charger or leave the adaptor connected at all times,
because there's no risk of overload.
• However, when not using the set for a long period of time (>2 months), it's
recommended to remove the adaptor from the wall socket and the battery from
the parent unit. When using the set again, you should first fully charge the
battery.
Table stand:
The rear of the parent unit is provided with a table stand. Unfold this stand to
place the parent unit on a table or cabinet.
40
Home