Operation - Husqvarna T525 Manuel D'utilisation

Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do a function check before you
use the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
2. Make sure that the throttle trigger lockout operates
correctly and that it is not damaged.
3. Make sure that the start/stop switch operates
correctly and that it is not damaged.
4. Make sure that there is no oil on the handles.
5. Make sure that the vibration damping system
operates correctly and that it is not damaged.
6. Make sure that the muffler is correctly attached and
that it is not damaged.
7. Make sure that all parts are correctly attached and
not damaged or missing.
8. Make sure that the chain catcher is correctly
attached.
9. Make sure that the saw chain tension is correct.
2 3
4
5 7
6
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result
in engine damage. Use a mixture of gasoline
and two-stroke oil.
Premixed fuel
• Use Husqvarna premixed alkylate fuel of a good
quality, for best performance and extension of the
engine life. This fuel contains less harmful chemicals
compared to regular fuel, which decreases harmful
exhaust fumes. The quantity of remains after
10

Operation

1
9
8
combustion is lower with this fuel, which keeps the
components of the engine more clean.
To mix fuel
Gasoline
• Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION: Do not use gasoline with an
octane grade less than 90 RON/87 AKI.
Use of a lower octane grade can cause
engine knocking, which causes engine
damages.
• We recommend that you use gasoline of a higher
octane grade for work with continuously high rpm.
Limbing is an example of such work.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
Two-stroke
oil, liter
2% (1:50)
0.10
0.20
0.30
0.40
732 - 015 - 11.12.2018