Operation - Husqvarna PAX1100 Manuel D'utilisation

To assemble the guard
1. Assemble the guard on the shaft. Make sure the
guard is assembled adjacent to the saw head.
2. Secure the guard to the shaft with the screw.
To assemble the suspension ring
1. Fit the suspension ring between the rear handle and
the loop handle. Position the hanging ring so that the
product is balanced and comfortable to work with.
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To check before starting
1. Inspect the working area. Remove any objects that
could be thrown out.
2. Check the cutting attachment. Never use blunt,
cracked or damaged equipment
3. Check that the machine is in perfect working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately lubricated. See,
To lubricate cutting equipment on page 14 .
6. Make sure that the cutting attachment always stops
when you release the throttle/power trigger.
8
3. Adjust the length of the harness until the support
hook is roughly level with your right hip.
To fill with oil
1. Open the oil cap on top of the bar head.
2. Fill with saw chain oil.
3. Attach the cap again.

Operation

7. Only use the product for the purpose it was intended
for.
8. Make sure the handle and safety features are in
order. Never use a machine that has any parts
missing or has been modified in relation to the
specification.
To use the product
WARNING: Observe the applicable safety
regulations for work in the vicinity of
overhead power lines.
WARNING: Never stand directly underneath
a branch that is being cut. This could lead to
serious or even fatal personal injury.
WARNING: If an emergency occurs, let
go of the product and let it fall to the
ground.
1349 - 003 -