Frost Protection - Bosch TES 501 Série Mode D'emploi

Masquer les pouces Voir aussi pour TES 501 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
en
G
LED
lights up.
● Open the drawer (4).
● Drop a Bosch cleaning tablet into the
drawer (4) and close it.
● Press the start button (10).
D
LED
lights up.
● Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it. When using TCZ6002,
2 tablets must be dissolved.
● Press the start button (10).
The service programme will now run for
a pproximately 10 minutes.
F
LED
lights up.
● Place a container with a capacity of at
least 0.5 litres under the milk frother
o utlet (6).
● Pull out the milk frother (6) to open it.
The service programme will now run for
a pproximately 12 minutes.
D
LED
lights up.
● Rinse the water tank (16) and refill it with
fresh water up to the max mark�
● Press the start button (10).
The service programme will now run for
approximately 30 seconds and rinse the
appliance�
F
LED
lights up.
● Push the milk frother (6) in to close it.
The service programme will now run for
a pproximately 8 minutes.
16
H
LED
lights up.
● Empty the drip tray (8) and reinsert it.
If you are using a filter, reinsert it now.
The appliance has been cleaned, descaled
and is ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.

Frost protection

¡
To avoid damage caused by frost
during transport and storage, the
appliance must be completely
emptied first.
Information: The appliance must be ready
for use and the water tank (16) filled.
1� Place a large container under the milk
frother outlet (6).
2� Press the steam button (11).
h
LED
flashes and the appliance now
heats up for approximately 20 seconds.
h
3� If LED
lights up, open the milk frother
(6) by pulling it out and release steam
for about 15 seconds.
4. Press the power on/off switch O / I (9) to
switch off the appliance.
5� Empty the water tank (16) and the
drip tray (8)�

Publicité

Table des Matières
loading

Table des Matières