Frost Protection - Bosch TES 503 Serie Mode D'emploi

18
N.B.: If the water filter is activated, the
display will prompt you to remove the
filter and then press the start button (10)
again. Remove the filter now if you have
not already done so. Press the start
button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (16) up to the 0.5 l mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it. When using TCZ6002,
2 tablets must be dissolved.
● Press the start button (10).
Calc'n'Clean in progress
The descaling pro g ramme will now run for
about 10 minutes.
Place container
Pull milk frother
● Place a receptacle with a capacity of at
least 1 litre under the outlet (6c).
● Pull the milk frother (6) to open it.
Calc'n'Clean in progress
The descaling pro g ramme will now run for
about 12 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (16) and refill it with
fresh water up to the max mark.
● Press the start button (10).
Calc'n'Clean in progress
The descaling pro g ramme now runs for
about 30 seconds and rinses the appliance.
Push milk frother
● Push the milk frother (6) in to close it.
Robert Bosch Hausgeräte GmbH
All manuals and user guides at all-guides.com
Calc'n'Clean in progress
The cleaning pro g ramme will now run for
about 8 minutes.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.

Frost protection

¡
Note: The appliance must be ready for use
and the water tank (16) filled.
1. Place a large receptacle under
2. Press the
3. Open the milk frother (6) by pulling
4. Switch the appliance off at the power
5. Empty the water tank (16) and the
To avoid damage from low tempera-
tures during transport and storage,
the appliance must be completely
emptied first.
outlet (6c).
h
button (11).
h
The button (11) flashes and the
appliance now heats up for approx.
20 s econds. The display then shows
Pull milk frother .
it out and release steam for about
15 seconds.
on/off switch O / I (9).
drip tray (8).
en