Settings - Bosch TES 501 Série Mode D'emploi

Settings

You can customize the settings on the
appliance�
You can make the following adjustments:
Water hardness
The water hardness setting can be adjusted
on this appliance. It is important to set the
water hardness correctly so that the appli-
ance can accurately indicate when it is time
to run the descale process. The factory
setting for the water hardness is 4. You can
establish the water hardness either by u sing
the test strip provided or by asking your
l ocal water provider.
Dip the test strip in the water briefly, shake it
gently and check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
If you wish to change the default degree
of water hardness, or if you have inserted
a water filter, proceed as follows:
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
A
(12) simultaneously for at least
5 s econds. The set water hardness is
indicated by the number of LEDs that
now light up.
3� Now press the start button (10) repeat-
edly until the required water hardness
is indicated, e. g., for water hardness 3,
D E
LEDs , and
4. Press and hold the start button (10)
for at least 5 seconds. The set number
of LEDs will light up to indicate that
the selected water hardness has been
saved successfully.
1-13
14-25
26-38
39-54
B
(11) and
F
will light up.
Important: If a water filter is used (see
"Accessories"), proceed as follows, see
"Water filter".
Note: If no button is pressed within
90 s econds, the appliance switches to
stand-by mode without saving the new
s ettings. In this case, the previously saved
water hardness setting is retained.
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off auto-
matically following the last drink preparation.
A time between 15 minutes and 4 hours can
be set. To save power you can specify a
shorter period.
1� Turn the rotary
knob (13) to position
2� Press and hold buttons
(12) simultaneously for at least 5 seconds.
The time after which the appliance
should switch off is indicated by the
number of LEDs that now light up.
3� Now press the start button (10) repeat-
edly until the required number of LEDs
light up to indicate the switch-off time:
D
= 15 minutes
D E
and = 30 minutes
D E F
, and = 45 minutes
D E F G
, , and
D E F G
, , , and
D E F G
, , , ,
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected switch-off time has been saved
successfully.
Note: If no button is pressed within
90 s econds, the appliance switches to
stand-by mode without saving the new
s ettings. In this case, the previously saved
switch-off time is retained.
B
(11) and
= 1 hour
H
= 2 hours
H I
and = 4 hours
en
A
9