Setup - Renkforce CD DJ CMP-960USB Notice D'emploi

7. Setup

When choosing the installation site, consider the specific constraints, such as the location of the
nearest power outlet etc.
When selecting the installation site, avoid direct sunlight, vibration, dust, hot and cold tempe-
ratures and dampness. Ensure sufficient ventilation when setting up the device with other
equipment. No strong transformers or engines are to be located near the device.
Keep a sufficient distance from heat sources. Do not point any strong spotlights or light sources
towards the device. This may cause overheating (danger of fire!).
Heat dissipation from the device must not be obstructed. Never place the device on any soft
surfaces such as a carpet or a bed. Do not cover the ventilation openings of the device. Air cir-
culation must not be obstructed by objects such as magazines, tablecloths, curtains or similar.
This prevents heat dissipation from the device and may lead to overheating (danger of fire!).
Only operate the CD player on a stable, horizontal surface not sensitive to heat.
Ensure a stable positioning, because the falling equipment can result in a considerable risk of
accidents.
Do not drill or screw any additional screws into the casing to mount the device. This may expose
dangerous voltage to touch.
Make sure that the connection cables are not squeezed or damaged by sharp edges. Always place
cables so that no one can trip over them or be caught in them. Danger of injury!
The cables must be of sufficient length. Do not put any mechanic strain on them. This may damage
the cables or device. There is a risk of dangerous electric shock.
Due to the diversity of furniture paints and polishes used, it is possible that the device's feet will
leave visible residue on furniture due to chemical reaction. The device therefore should not be
placed on valuable furniture surfaces without any suitable protection.
• The CD player is set up on a level, horizontal surface. Otherwise, CDs cannot be read or played back properly.
• The device can also be installed in a DJ desk. There are thereto attaching holes in the cover plate of the control
unit and of the drive unit.
37