Commissioning; Switching On; Inserting A Cd - Renkforce CD DJ CMP-960USB Notice D'emploi

10. Commissioning

Only put the device into operation once you have become familiar with its features and these
operating instructions. Check again that all connections are correct. Do not put the product into
operation if it is damaged.
Always switch on the system's amplifier last and off first. This will prevent any undesired noises
(which can typically occur when switching off the CD player) from damaging the amplifier or
loudspeakers.
Make sure that the connected devices are not overloaded. Playback must never be distorted. If
distorted music signals can be heard although the volume on the amplifier is not set too high,
switch off the CD player immediately and check the connection. If the connection is correct, please
contact a specialist.
The device must only be operated by persons familiar with the operating instructions and observing
them.
The CD player can play music files in the MP3 format. MP3 is a file format to compress music. Save the
MP3 files on a CD, SD card or USB drive and play these on the CD player without the need to connect
this to your computer. Different formats, bit rates, sampling frequencies, encoding procedures and playlists
make it possible that not all tracks are recognised.

Switching on

• Turn the volume control of the connected amplifier down completely.
• Push the power switch (1) to switch on the CD player.
• Then switch on the mixer, if connected, and then the amplifier.

Inserting a CD

Do not insert any damaged CDs into the player. The high rotational speed may cause it to crack and
damage the device. Do not insert more than one CD.
Compatible with audio CD (COMPACT DISC DIGITAL AUDIO), CD-R, CD-RW and MP3 CD.
Multi- session CDs are not supported.
Never interfere with the motor-driven movement of the CD tray (34).
• Push this button EJECT (14 / 33) to open the CD-tray. Place an audio CD in the CD tray with the labelled side
upwards. Hold the CD at the outer edge and do not touch the CD on the inside.
• Push this button EJECT (14 / 33) to close the CD-tray. The CD is drawn in and then read.
• Then, the device automatically sets the CUE mark at the beginning of the first track on the CD and goes into pause
mode. You can now start playback.
The CD cannot be ejected during playback mode. This makes sure that the playback is not interrupted
unintentionally. Terminate playback before pushing the EJECT button (14 / 33).
39