Checking The Cue Mark; Deleting A Cue Mark; Loop Function (Playback Loop); Playback Speed Synchronisation - Renkforce CD DJ CMP-960USB Notice D'emploi

Checking the CUE mark

• During playback, push the CUE button (2).
• The device returns to the CUE mark and pauses.
• Hold down the CUE button (2).
• The music is played from the CUE mark as long as you hold down the CUE (2) button.
• When the button is released, the CD player returns to the CUE mark and pauses.

Deleting a CUE mark

• The old CUE mark is deleted once a new CUE mark is set.

LOOP Function (playback loop)

The device allows you to save a "seamless" play LOOP. The start and end point of the LOOP can be set in pause or
playback mode.
Saving and playing back the LOOP function:
• At the desired starting point of the play loop, push the LOOP IN button (5). The LOOP IN LED is lit.
• At the desired end point of the play loop, push the LOOP OUT button (6). The LED LOOP IN and LED LOOP OUT
flash.
• The playback loop is now played continually.
• Push the button LOOP OUT (6) to stop the play loop.
• A stored playback loop is indicated when the LED LOOP IN and LED LOOP OUT buttons are lit. Push the RELOOP
(7) button to start the stored loop again
The present loop is deleted when a new loop is programmed, a new track is selected or the SEARCH
buttons

Playback Speed Synchronisation

To mix or cross-fade two signal sources cleanly, the beats have to be synchronised in many cases.
This can be achieved in three ways:
• Using the PITCH slide control (9). It allows you to permanently modify the speed. This function is used when two
tracks have two completely different tempos.
• Using buttons PITCH BEND (16 and 17). This allows you to change the speed temporarily. This function is used
when two tracks have the same beat but the starting point has to be synchronised.
(24 / 23) are pushed in MP3 mode.
43