Wire Connection - Clarion NAX963HD Manuel D'installation Et De Connexion

0426-UK.book Page 9 Wednesday, April 26, 2006 10:52 PM

Wire Connection

Be sure to read the section "Safety Precautions" before installation or connection operations.
Example of connecting to the VRX868RVD
2 Power supply lead
NAX963HD
4 Microphone
for voice control
7 RDS-TMC
antenna
Notes on Installing the 7 RDS-TMC Antenna
• For vehicles that do not allow radio wave penetration such as heat reflection glass, heat insulation
glass or radio wave interception glass, the receiver sensitivity may decrease. For details, speak to the
dealer where you purchased the unit.
• The receiver sensitivity may weaken by interference from other antennas within the vehicle, therefore
try to install it away from other antennae.
• To prevent noise, wire the antenna cable separately from the power supply lead, speaker leads and
the other cables of the vehicle.
WARNING
Pink Speed sensor
Connect to the engine control computer vehicle speed signal line.
For details, see Connecting to the Speed Sensor.
Green Handbrake
Connect to the handbrake lamp lead.
After connecting, pull the handbrake and check that
the line falls to ground.
* Some functions will not operate unless you connect to the
handbrake.
* This is a safety mechanism. Connect correctly.
Fuse
Yellow
5A
Purple/white
Black Ground
Connect to a metal part of the vehicle to connect ground.
VRX868RVD
3 GPS antenna
6 RGB cable
5 CeNET cable
Main power supply
Connect to the +12V power supply
where power source is always supplied.
Reverse gear signal
Connect to the + terminal for the reverse
gear lamp that is only fed when
the transmission is put in reverse.
NAX963HD
9