Specifications; Installation/ Wire Connection Guide; Before Starting - Clarion NP400 Mode D'emploi Et Manuel D'installation

5. SPECIFICATIONS

Navigation
Memory: NAND Flash Memory
Upgrade Platform: USB
TTS (Text to Speech): Street Announcements
Find Menu: Address, POI, History, Coordinates, Favorites,
Plan on map
POI: 1 million
Road Selection: Unpaved, Permit needed, Motor ways,
Toll, Ferries, Border crossing, Carpool
lanes
INSTALLATION /WIRE CONNECTION GUIDE
CONTENTS
1. Before Starting ..................................................................................................................17
. Package Contents .............................................................................................................17
3. General Cautions...............................................................................................................18
4. Cautions On Installation ....................................................................................................18
5. Cautions On Wiring ...........................................................................................................18
6. Wire Connections ..............................................................................................................18

1. Before Starting

1. This set is exclusively for use in cars with a negative ground
1V power supply.
. Read these instructions carefully.
3. Be sure to disconnect the battery" "terminal before starting.
This is to prevent short circuits during installation. (Figure 1)
2. Package Contents
Main Unit ............................................................. 1
GPS Antenna ....................................................... 1
Connector Cable ................................................. 1
Installation Brackets ............................................ 
Warranty Card ..................................................... 1
Owner's Manual and Installation Manual ............ 1
All manuals and user guides at all-guides.com
General
Power source voltage:
14.4 V DC (10.8 to 15.6 V allowable)
Ground: Negative
NP400 dimensions:
6-9/16" (166mm) width, 1-1/4" (30mm) height,
4-5/8" (117mm) depth
NP400 weight: 1lb (454g)
Note:
• Specifications and design are subject to change without
notice for further improvement.
NP400 17