Connecting The Speed Sensor - Clarion NAX963HD Manuel D'installation Et De Connexion

0426-UK.book Page 8 Wednesday, April 26, 2006 10:52 PM
Installing the Microphone for Voice Control
1. Clamp the microphone at the window side of the sun visor using the clip, and turn it towards the
mouth of the person who operates the system.
Fasten the cable to the pillar using the cord holders.
During bright sunlight and using the sun visor, clamp the microphone at the side of the sun visor, and
turn it toward the mouth of the person who operates the system.
* When the microphone cannot be clamped firmly because the clip is larger than the sun visor, insert a
sponge rubber between the clip and the sun visor.
* If it is hard to clump to the sun visor, consult the dealer where you purchased this unit.
4 Microphone for voice control
8 Cord holder

Connecting the Speed Sensor

IMPORTANT
Take care when connecting to the EC (Engine Control Computer) vehicle speed signal cable/lead.
1. Confirm the position of the EC (Engine Control Computer) and the vehicle speed signal cable
referring to your car make/model.
2. Remove the vehicle parts, and confirm the position of the vehicle speed signal line of the EC.
3. Connect the vehicle speed signal line and the speed sensor connection lead of the power supply
harness of this unit using the electro-tap (for speed sensor).
4. Connect the negative terminal of the battery and start the engine.
Drive the vehicle slowly and check that the signals are proportional to the vehicle speed and are
correctly detected by displaying the connection check screen (see the "System Check" section of the
operation manual).
EC vehicle speed signal cable
8
NAX963HD
Engine control computer (EC)
Vehicle speed harness
4 Electro-tap (for speed sensor)
Speed sensor connection lead