Uploading From A Usb Drive - Ovention Double MiLO Manuel D'installation Et D'utilisation

OPERATION

Uploading from a USB Drive

Use the following procedure to upload pre-programmed menu
items or firmware updates from an external USB drive. This
procedure requires access to password-protected screens and
should be performed at oven startup by authorized personnel
only.
NOTE: USB drive must have a capacity of 64 GB or less.
1. Remove the cover from the USB port next to the
touchscreen, and insert the USB drive into the port.
2. Move the Standby switch up to the "On" position.
• The touchscreen will energize and show
the name of the oven and current software
version for a few seconds.
3. Touch the upper left-hand corner on the touchscreen.
• A password keypad will appear on the touchscreen.
Touch here to access password keypad
followed by the Admin Mode screen.
Startup Screens
4. Input the password using the keypad, and touch ENTER.
• The Admin Mode screen will appear.
5. Touch USB to access the USB Functions screen.
Touch to upload touchscreen
firmware update.
Touch to upload relay
firmware update.
USB Functions Screen
"On"
Touch to upload
pre-programmed
menu items.
6. Touch the desired function to begin the corresponding
upload.
• Select the upload file from the list that appears.
• A screen will appear to indicate that the upload is in
progress.
• When the upload is complete, the oven will restart.
7. When the startup screen reappears, remove the USB drive
from the USB port, and replace the port cover.
8. Perform the normal "Startup" procedure at the beginning of
this section to use the oven.
14
English
Form No. OVMILOM-0817