Preparing The Appliance; Setting The Time; Preparing Coffee - SEVERIN KA4810 Mode D'emploi

4 Preparing the appliance

1. Remove all protective films and other packaging material from
the appliance.
2. Set up the appliance in a place that fulfils the following conditions:
• Near a socket outlet with earthing contact (fuse at least 10 A)
Horizontal and free from vibration/shocks
•
• Heat-resistant
• Does not react to rubber pads
Away from heated or flammable surfaces and objects (> 1 m)
•
Away from walls (> 15 cm)
•
3. Clean the appliance as described under ►"7.2 Daily cleaning" on
page 30.
4. Run water through the appliance as described under ►"7.3 Running
water through the appliance" on page 30.

Setting the time

TIP
You must first set the time to ensure the program-
ming function works correctly. If you do not wish to
use this function you can skip setting the time.
1. Repeatedly press the "h" button to set the hour.
2. Repeatedly press the "min" button to set the minutes.
 The time is now set.

5 Preparing coffee

WARNING!
Risk of scalding!
– Do not place parts of the body under the drip
stop while the appliance is in operation.
CAUTION!
To avoid damaging the appliance only fill the water
tank with cold tap water.
TIP
The display switches off 35 minutes after making
coffee or, if coffee is not made, 1 minute after the
last entry. To turn on the display again, press one
of the buttons at the front of the appliance. Press
the " " button only when you wish to start brewing
directly.
TIP
You can interrupt the brewing function at any time by
pressing the " " button. Water remains in the water
tank when you interrupt the brewing function. Empty
the water tank by removing the disposable coffee
filter or permanent filter from the filter insert, placing
the empty coffee jug on the hotplate and continuing
operation after pressing the "GRIND OFF" button
followed by the " ".
GB
25