KitchenAid KUIX535HPS Instructions D'installation page 14

Option 2 - With Hinge-Side Spacer
To achieve a flush installation with adjacent cabinets, prepare the
custom overlay panel using the dimensions shown.
(37.1 cm)
Top of Panel
A
A. Front-visible surface when installed
B. Hinge Side
Bottom of Panel
A. Front-visible surface when installed
B. Hinge Side
Custom Panel Installation
1. From inside the door, install two wood screws through the
slotted holes in the top and bottom door brackets. Adjust the
panel side to side to achieve a 1/8" gap on both sides. Install
the remaining screws through the door bracket into the panel.
2. Replace the side caps into the door panel. Tighten all screws
to secure position.
14
29 ¹⁄₂"
(74.9 cm)
14 ⁵⁄₈"
B
A
B
Installation into cabinet
WARNING
Crush Hazard
Articulated hinges are self closing and many pinch
points exist prior to cabinet installation.
Do not remove hinge covers until product is ready to
be installed.
Failure to follow these instructions can result in crush,
cut, or pinch injuries.
1. Remove the hinge cover from the upper and lower hinges.
2. To remove, cut hinge cover at indicated point using diagonal
cutting plier and remove from around hinges. Unscrew and
remove the side caps in the door by sliding them out.
NOTE: Reinstall the hinge covers if product is removed from
cabinet installation.