Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Take the original lower side end cap, flip it 180 degrees, and
place it on the upper hinge position on the non-hinged side.
NOTE: The end caps should be on the opposite corner on
which they started, and opposite sides on the hinges.
5. See the graphic below to verify completed end cap reversal
on your appliance.
Final Door Placement
NOTE: Before placing the door back on the ice maker, check all
installed parts to ensure there are no exposed screws, all screw
cover caps are on, and the door is facing the correct way with the
stainless steel door facing out.
1. Slide the door panel behind the hinges. The screws will go in
through the hinge first, and then the door panel.
12
2. Place the steel door panel back on the door once all screws
are tightened.
3. Screw the two hex heads screws back in at the bottom of the
door.
Reverse Door Catch
1. Remove the white decorative screws from the opposite side
of the door and set aside.
2. Remove the screws from the magnetic door catch and place
them on the opposite side of the door.
Publicité
Table des Matières
