Error Message; Accessories - IKA ULTRA -TURRAX Tube Drive Mode D'emploi

Attaching the tube
Fit the tube carefully and en-
sure it is properly attached.
Setting the speed
Set the desired speed in the range of
300 - 6000 min -1 using the infinitely
adjustable rarotary knob (B).
Starten
Press "Start/Stop" button (C),
while the preset countdown is running,
timer display will blink.
An audible signal will be given when
the countdown is complete.
Cancelling the countdown
Press button "Start/Stop "(C).
Ausschalten
Press button "Power" (A).
8

Error message

It is possible for the media to become lodged between the cutters
of the DT-tubes. The unit will automatically change the direction
of rotation up to three times in an attempt to free the cutters. The
unit will switch off automatically if this is not possible.
If the device becomes blocked on three occasions within a certain
period of time the following error message will occur:
 Display:
 An audible signal will be given.
Corrective action: Switch off the device, check contents,
switch on the device.
4
5
6
3
2 7
8
1
9
0
9

Accessories

• ST-2
Power
• ST-20
• ST-20-M-gamma Tube with stirring device 20 ml,
• ST-50
• ST-50-M
Start
Power
Stop
• ST-50-M-gamma Tube with stirring device 50 ml,
• DT-20
Power
• DT-20 eco
• DT-20-M-gamma Tube with dispersing device 20 ml,
• DT-50
• DT-50 eco
• DT-50-M
• DT-50-M-gamma Tube with dispersing device 50 ml,
Tube with stirring device 2 ml
Tube with stirring device 20 ml,
with pierceable membrane
γ-sterilized, with pierceable membrane
Tube with stirring device 50 ml
Tube with stirring device 50 ml,
with pierceable membrane
γ-sterilized, with pierceable membrane
Tube with dispersing device 20 ml
with pierceable membrane
Tube with dispersing device 20 ml, with PSU rotor/stator
γ-sterilized, with pierceable membrane
Tube with dispersing device 50 ml
Tube with dispersing device 50 ml, with PSU rotor/stator
Tube with dispersing device 50 ml,
with pierceable membrane
γ-sterilized, with pierceable membrane
15