Güde GH 2400 Traduction Du Mode D'emploi D'origine page 13

Minimum age
The machine can only be operated by persons over 16
years of age. An exception includes youngsters operating
the machine within their professional education to achieve
necessary skills under trainer's supervision.
Training
Using the machine only requires appropriate instructions
by a professional or reading the Operating Instructions.
No special training necessary.
Servicing and keeping
Switch the machine off and unplug it before any
servicing and cleaning.
Keep the ventilation slot and body without any dust and
dirt.
To clean the machine, use a smooth and fine soap water
solution. Prevent any direct contact of aggressive cleaning
agents with the machine. No aggressive, volatile or caustic
cleaning agents may be used.
Once a year, have the electric garden shredder checked
by a qualified authorised professional.
The machine needs to be protected against moisture and
dust.
If the machine is used for a longer time, keep it covered in
a dry, safe place inaccessible to children.
Changing the knife (pic. G)
Wear safety gloves when changing the knife!
Open the cover and loosen the knife (pic. G).
A rotating knife is inbuilt in your garden shredder.
Therefore, you must just turn the knife and tighten it using
the Allen key when replacing the knife for the first time.
Close the cover again after turning/changing both knives.
Troubleshooting
The table shows possible failures, their causes and
remedy options. If the problem still cannot be removed,
contact a professional to help you.
Switch the machine off and unplug it before any
servicing and cleaning.
Risk of electric shock.
Symptom Possible cause
Machine Collection box not
not running fitted properly
Feeding hopper not
fitted properly
Defective outlet
Extension cable is
damaged
Fuse has been
activated
Overload protection
has been activated
Shredded Shredded material
material is wet and soft
Remedy
Install the collection box
properly
Install the feeding
hopper properly
Use another outlet
Check or replace the
cable
Change the fuse
Press the overload
protection button (pic.
A/8) and remove the
blocking as specified in
"Operation"
To insert the shredded
material in the machine,
13
not pulled
in
Shredded material
has got jammed in
the machine
Service
Any technical questions? Complaint? Do you need
spare parts or operation manual?
Go to our website www.guede.com and the section
Service will help you quickly and without bureaucracy.
Please, help us to help you. In order to identify your device
in case of complaint, please indicate serial number, order
number and year of manufacture. All information is
available on the product label. To have all information
always at hand, put them down.
Serial number:
Order number:
Year of manufacture:
Phone: +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com
Important information for the customer
Please be sure to know that returning the product in or
after the warranty period must be made in the original
packaging.
use the sliding part
Remove the blocked
shredded material
(safety gloves to be
worn at all times)