Publicité
Les langues disponibles
Les langues disponibles
Use as designated
The machine has been designed to shred fibrous and
woody garden waste. The collection box has only been
designed for collecting (not storing) the shredded material.
Never stand on the collection box.
The machine cannot be used for works other than for
which the machine has been designed and that are
specified in the Operating Instructions. Any other use is a
use in conflict with the designation. The manufacturer will
not be liable for any consequential damage and injuries.
Please be sure to know that the machine has not been
designed for industrial purposes.
Assembly
Caution! The machine must be switched off and unplugged
before any servicing, cleaning and assembly. The same
must be done if the feeder cable has been damaged, cut
or entangled.
Respect the system voltage: The current source voltage
must match the details on the type label of the machine.
An extension cable with a small conductor cross-section
significantly reduces the machine performance. At least 3 x
1.5 mm² for cables with length to 25 m and at least 2.5
mm² for cables longer than 25 m. Caution! Extension
cables not specified must not be used. The extension
cable, plug and coupling must be watertight and approved
for outdoor use.
Cable connections must be dry and must not lie on the
ground.
If a cable reel is used, it must be unreeled.
Proceed as follows (pic. B-F):
Take the machine out of the package and install the
axis, transport wheels and the collection box
(pic. B-F).
Operation
Put the machine on a solid and even surface at all times.
Never tilt or move the machine when the engine is running.
Caution! The engine runs down after switching the
machine off.
Remove earth from root balls and prevent undesirable
items, e.g. stones, glass, metals, plastic or textile materials
from entering the feeding hopper and subsequently to the
machine and cutting cylinder as the machine could get
damaged.
The feeding hopper must be empty.
Switching the machine on:
Press the ON/OFF switch (pic. A/9) up.
Switching the machine off:
Press the ON/OFF switch (pic. A/9) down.
Restart protection
The restart protection prevents accidental machine start
after power failure.
Overload protection
If the machine is exposed to a high load (e.g. cutting
cylinder is blocked), it stops after a couple of seconds.
Working instructions
Insert only such amount of shredded material that
the feeding hopper does not get blocked.
Do not shred soft waste without any solid
consistency but compost it straight away.
Make sure the shredded material falls to the
collection box or collection bag unobstructed –
risk of getting blocked!
Optimum results are achieved when shredding
fresh branches shortly after they have been cut.
Never touch in the opening, not even when the
engine is off. Knives are sharp! To insert shredded
material in the opening, use the feeding help.
Marking
Product safety:
Product corresponds to
applicable EU standards
Prohibitions:
No pulling the plug!
Warning:
Warning/Caution
Warning against thrown-
away items
Unsuitable for outdoor
spaces
Commands:
General command sign
Use protective glasses and
headphones
11
Protect against rain and
moisture!
Warning against dangerous
voltage
Warning! Rotating machine
represents a risk of injury!
Keep bystanders in safe
distance from the machine.
Please read the Operating
Instructions before using the
machine
Protective gloves to be used
Publicité
