Maintenance And Storage - Ribimex Ribitech PRS30 / 310106 Manuel D'instructions Et D'utilisation

V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for sharpening bits and straight blades within the limits of the
sharpener.
- This power tool may not be used to do other things outside of the described scope.
- Do not use the machine for unsuitable purposes (for ex. for cutting wood, metal, plastic,...)
- The tool is not intended for professional, artisanal or industrial use.
5.2- Operation:
1. Prepare bit/blade for sharpening (clean it as necessary) and lay it properly on the attachment.
2. Adjust settings according to the specifications for your blade or according to your needs.
3. Connect tool to a power source (refer to characteristics on product).
4. Wear appropriate protective equipment.
5. Firmly hold tool. Always maintain a balanced and secure position.
6. Press ON switch (I) to start machine.
7. Start sharpening (Refer to 4.6)
8. Do not make sudden movements.
Do not apply excessive pressure.
9. Once work is finished, stop product by pressing OFF switch (0).
Note: do not touch tool until the sharpening wheel has come to a complete stop.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected from its
power source.
Reminder: Make sure to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage .Any breach or default of adequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
6.1- Cleansing
Clean plastic parts with a soft and clean cloth
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not use any caustic to clean the plastic parts.
Do not put or immerse tool in water or any other liquid, and ensure that no water gets inside the
tool.
Clean ventilations holes with a soft brush or with compressed air.
6.2- Changing the grinding wheel
This intervention MUST be performed with the machine unplugged and with sharpening wheel at
a standstill.
To replace a grinding wheel, proceed as follows:
1. Remove the attachment (see 4.4).
Page 26 of 45