Maintenance And Storage - Ribimex PRPBD900 Manuel D'instructions Et D'utilisation

4.4- Switch On/Off
Switch On/Off
•
Connect the tool to the main power source.
•
Pull the power trigger switch (4) to start the sander.
•
For continuous sanding operation, pull the power trigger switch (4), then press the trigger
lock (5). To stop the sander, press the trigger lock (5) again to release the trigger.
V. OPERATION
5.1- Intended use
This power tool is intended for indoor domestic use. This is suitable for sanding surfaces of
wood, plastic and metal materials, as well as painted surface. Do not use on materials containing
asbestos or other hazardous materials. The tool is not intended for artisanal, commercial,
professional and / or industrial use.
5.2- Operation
Sanding operation
•
Hold the machine with both hands in a stable position, then switch on the machine without
loading for few seconds.
•
Rotate the speed admentment dial (9) to adjust the abrasive belt speed.
•
Stop the machine immediately in case of abnormal vibration or noise.
•
Gently place the tool on the workpiece surface.
•
Always keep the belt flush with the workpiece and move the tool back and forth.
5.3- Tips
•
Wait until the motor running in full speed before starting your work.
•
Never force the tool. Excessive pressure could result in stalling, motor overheating,
burning of workpiece or possible kickback.
•
When finishing sanding, lift the sander off the work surface and release the trigger.
•
To maintain efficiency, empty the dust collection bag when no more than half full.
VI. MAINTENANCE AND STORAGE
WARNING!
Before any intervention on product, ensure that power is set to the "OFF" position
and disconnect from main power source.
Reminder: In order to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage. Any breach or inadequate
maintenance reduces the life of the machine and increases the risk of breakdowns and accidents.
6.1- Cleaning
•
Before cleaning, turn off the tool and disconnect from power source.
•
Clean the machine with a dry clean cloth. Do not use water or detergent for cleaning.
•
Never immerse the machine in water or any liquids.
•
Always keep the ventilation holes clean.
Page 11 / 18