Ribimex Ribitech PRS30 / 310106 Manuel D'instructions Et D'utilisation page 25

a. Fig.7a + Fig.6 - Insert the blade in the groove (a) until it comes into contact with the grinding
wheel. Note: you can install the blade on the support (b).
b. Fig.7b - Make a back-and-forth to spend the whole blade on the wheel.
c. Fig.7c - Turn the knife and insert the blade into the other slot (a) and repeat the sharpening
procedure.
d. Start the sharpening process (if necessary) until desired sharpening.
4. Scissors blades
a. Fig.7d + Fig.6 - Insert the blade into the slot (a) until it comes in contact with the grinding wheel.
Note: you can install the blade on the support (d).
b. Fig.7e - Make a back-and-forth movement so as to travel the whole blade on the wheel.
c. Fig.7f - Turn the scissors and insert the other side of the blade in the slot (a) and repeat the
sharpening procedure.
d. Repeat the sharpening process (if necessary) until desired sharpening is achieved.
e. Note: You can also sharpen scissor blades through the grooves (a).
5. When finished, switch off the tool. Wait until the grinding wheel has stopped spinning.
Clean and store the sharpener.
4.6.3- Sharpening cutting tools' blade
The sharpener is designed to sharpen chisel or plane or flat and straight blade of cutting tool form
6 to 51mm width. Do not sharpen serrated blade.
Attention! Do not use the tool if the protective shield (a) is missing, cracked or damaged.
1. Install the attachment (2) for cutting tool blade on the main unit (1) [cf. 4.4].
2. Fig. 9a + Fig.8 - Place the blade on the plate rest (c) so that the cutting edge of the blade
touches the grinding wheel. The two magnets (e) will help holding the blade in place.
3. Fig.9B, 9c + Fig.8 - Setting the sharpening angle.
Loosen the knob (b) then adjust the plate angle (c) to the desired angle (adjustable between 15°
and 50°).
Make sure that the sharpening angle corresponds, at best, to the beveled angle of your blade.
4. Switch on the sharpener.
5. Fig.9d - Slide the plate (c) back and forth, so that the cutting edge of the blade passes over the
wheel. Use light pressure on the blade and conduct regular and uniform motion.
WARNING! Never leave the blade stationary, as this would result in an uneven sharpening.
6. Fig.9e - Gradually adjust the blade down the plate while sharpening. Do not press hard, grind
gradually.
7. Fig.9f - Remove the blade and verify its sharpening.
8. Repeat the sharpening process (if necessary) until desired sharpening is achieved.
9. Fig. 9g - For narrow blades, place the small guide (f) on the edge (e) and placing the support
plate against the spacer.
10. When finished, switch off the tool. Wait until the grinding wheel has stopped spinning.
Clean and store the sharpener.
Tips: after sharpening a blade, it is recommended to clean the blade edge and apply oil stone on
it.
Page 25 of 45