Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are removed from the tool
before turning it on.
17. Avoid unintentional starting
Ensure switch is in "off" when plugging in.
In case of voltage failure or electrical shortage, place the switch on the OFF position, so as to avoid
any danger due to unintentional start of the product after voltage recovery.
18. Use outdoor extension leads
When the tool is used outdoors, use only extension cords intended for outdoor use and so
marked.
19. Stay alert
Watch what you are doing. Use common sense. Do not operate tool when you are tired, under the
influence of alcohol, prescription medicines or drugs.
20. Check damaged parts
- Before further use or reuse of the tool, tool should be carefully checked to determine that it will
operate properly and perform its intended function.
- Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and
any other conditions that may affect its operation.
- Any parts should be installed properly to comply with the conditions of the machine safe
operation.
- A guard or other part that is damaged should be properly repaired or replaced by an authorized
service centre unless otherwise indicated in this instruction manual.
- Have defective switches replaced by an authorized service centre
- Do not use the tool if the switch does not turn it on and off.
- Never use damaged disks or accessories.
- Regularly check the disks for signs of wear or damage.
21. Warning
The use of any accessory or attachment, other than one recommended in this instruction manual
may present a risk of injury (to persons or animals) and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
22- Have your tool repaired by a qualified person
This electric tool complies with the relevant safety rules. Repairs should only be carried out by
qualified persons using original spare parts; otherwise this may result in considerable danger to
the user.
23. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above.
24. Special safety guidelines
24.1. Check the grinding disk before use for possible damages. Do not use grinding disks that are
cracked, torn or damaged
24.2. Check that the rotation speed given on the disk is greater than or equal to the rated speed of
the machine
24.3. The grinding disk must be securely installed with the mounting nut.
24.4. The screws on the protective device must be properly screwed on.
24.5. The spark protecting cover must be set in the appropriate position to avoid any hazard to
the user.
Page 21 of 45
Publicité
Table des Matières
