Ribimex Ribitech PRS30 / 310106 Manuel D'instructions Et D'utilisation page 23

fatal injury, we recommend persons with medical implants to consult their physician and the
medical implant manufacturer before operating this machine.
13. WARNING
A certain level of noise emitted from this machine is not avoidable.
Plan noisy work according to local laws and at specific times.
Keep rest periods and if necessary restrict the working hours to a minimum.
For your own personal protection and the protection of bystanders wear suitable hearing
protection.
Follow the operating time and rest time of the tool.
14. WARNING
Sharpening may create sparks, do not use near flammable materials, liquids or gas.
Never use the sharpener WITHOUT an attachment fitted.
IV- GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Presentation
The sharpener is delivered pre-assembled.
One part consists of the base including the motor unit and the sharpening wheel.
The other parts are made of the 3 attachments.
4.3- Installation
1. The assembly shall be performed with the machine unplugged!
2. The tool is intended for horizontal installation.
Place tool on a flat, stable and solid surface or a workbench.
3. Whenever permanently installing it on a desk or workbench: put the machine on the desk /
workbench and screw it to the desk /workbench using the holes (pos.9 Fig.1) in the base (screws
and bolts not supplied).
Important: at this stage, sufficient space around the main unit (1) for ease of installation of the
attachments.
4.4- Inserting and removing an attachment
1. This intervention MUST be performed with the machine unplugged and with sharpening wheel
at a standstill.
2. To insert an attachment
a. Take an attachment (for ex in Fig.2, the scissors and knives attachment)
b. Align and insert the two lateral ribs (a) in the grooves (7) of the main unit.
c. Make sure to engage the locking tab (6) in the slot (b) at the bottom of the attachment.
d. Make sure the attachment is assembled correctly and firmly maintained by the locking tab (6).
e. Whenever an attachment is in use, you can store the other two attachments on the other sides
of the main unit (see Figure 3)
3. To remove an attachment:
a. Raise the locking tab (6) from the slot (b) at the bottom of the attachment.
b. Slide upwards the attachment grooves (7) until it is detached from the main unit.
Page 23 of 45