Ribimex Ribitech PRS30 / 310106 Manuel D'instructions Et D'utilisation page 22

24.6. A disk that is already damaged or deformed should not be further used.
Use only original grinding wheel, which is delivered or recommended by the manufacturer.
25. Handling, transport and storage of grinding disks:
Grinding disks are fragile, as well as sensitive to impact and shocks.
Therefore, special precautions are necessary:
a) Do not let the grinding disk fall and avoid impacts effects.
b) Do not use a dropped or damaged disks.
c) Avoid vibrations or vibrations during application
d) Avoid damaging the mounting bore
e) Avoid loads on the sharpening surface
f) Store grinding disks flat or perpendicularly, keep dry, protected from frost and at a constant and
medium temperature.
g) Keep the grinding disks in their original packaging or in special containers and on shelves.
(C) Safety warnings regarding the use
Important notice! Observe any national safety regulations regarding installation, operation and
maintenance.
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
4. Use only accessories with a permissible speed at least as high as the no-load speed of the
machine.
5. Do not use tool if damaged, eccentric or vibrating.
6. Do not use damaged, cracked, eccentric or vibrating disks.
7. Never seize or touch the disk during operation
8. Position power cable in a way that it is not trodden on or damaged during use.
9. If the power cable is damaged, it must be replaced by a special assembly available at the
manufacturer's or its after sales service.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect
plug from its main power source. Do not touch the cable or extension cord before unplugging
from main power.
10. Grinding may create dust and projection of debris. Wear appropriate protective equipment
(dust mask, safety goggles...).
Use dust extraction device when available, and ensure that it is properly connected and used.
11. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Bruising hazard if the grinding wheel is touched while in operation.
d- Exposure to electricity by using a non-standard defective electrical connection lines.
12. WARNING!
This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or
Page 22 of 45