Sirius SLTC919 Instructions D'utilisation Et Avis De Montage page 13

WORKING
Mod. SL TC – Glass (dis. 11)
A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 - minute timer
The touch control key allows the function desi-
red by touching the relative key.
If the electrical power supply to the product
SLTC is cut, 15 seconds are needed for selfdia-
gnostics after the functions are restored.
In the meanwhile, its operation may be incor-
rect.
The products are endowed with an electronic
device which allows the automatic switching off
after 4 hours working from the last ope r ation.
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suction
speeds control, when the air capacity exceeds
650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equipped
with a timer device that automatically switches
the suction speed from 4th to 3rd speed, after
5 minutes operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter pa-
nel. It can be removed by pushing its special
handle toward the back-side of the cooker
hood and turning the filter downwards so to
unfasten it from its slot (Fig. 4).
To insert the filter just perform the opposite
operation.
After 30 hours working (model), the push
button control panel will signal the saturation
of the grease filter by lighting all the buttons.
Press the timer button to reset .
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter (Fig. 12) ne-
eds to be periodically replaced. The coal filter
can be removed by removing the grease filter
first (Fig. 4), and by pulling its special pla-
stic tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the
opposite way. The coal filter needs replacing
depending on the use, but however every six
months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
LED BAR REPLACEMENT
To remove the led bar , it is recommended to
remove the steel bar as shown in Fig. 6 and 7,
then disengage the led bar by acting on the
specific fastening springs.
Replace the led bar with one of the same cha-
racteristics.
Refit the steel bar.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in or-
der to avoid a hazard.
13