Sirius SLTC919 Instructions D'utilisation Et Avis De Montage page 12

* In its sucking version (Fig.2), fumes are di-
rectly conveyed outside, through an evacua-
tion duct connected with the superior part of
the wall or the ceiling. Both coal filter and air
deflector are not necessary in this case.
INSTALLATION
Remove the grease filters before installing
the product, in order to avoid to damage the
appliance.
Open the glass by rotating it as shown in fig.
3; then remove the grease filters by acting on
their specific handle and rotate them to re-
move them from their seating (fig. 4).
Make an opening on the kitchen cabinet bot-
tom of the following sizes:
SLTC919 520: 265mmX498mm
SLTC919 850: 265mmX835mm
Make sure the cabinet structure and the ma-
terial used allow you to make this opening
without causing any damages, even during
the appliance installation.
Prepare the power supply inside the cabinet.
Prepare the air discharge hole for the product
being installed either in the sucking or filte-
ring mode.
Use an air discharge pipe whose maximum
length does not exceed 5 meters.
Limit the number of elbows in the piping, as
each elbow reduces the air capacity of the
hood of about 1 linear meter. (Eg.: if you use
no. 2 x 90° elbows, the length of the piping
should not exceed 3 meters).
Avoid abrupt direction changes. Use a 150mm
constant diameter pipe for the whole length.
Use piping approved standards in force.
Remove the fixing screws of the rear steel
bar, as shown in fig. 5.
Rotate the steel bar, including the led bar, to
remove it from its seating (fig. 6- 7). You can
electrically disconnect the bar by acting on
the specific connector.
Place the appliance inside the cabinet and fix
it by inserting the screws supplied into the
holes, as shown in fig. 8.
Both in the front and rear side of the applian-
ce.
Refit the stainless steel bar previously remo-
ved , connect the led bar electrically by means
of the specific connector, and then refit the
grease filter.
Rear air outlet
Models equipped with only one motor can be
installed having the motor air out let oriented
towards the appliance rear side.
If you choose this option, you will need to
remove the motor support by removing the
18 screws (fig. 9), taking out and rotating
the support, placing it in its housing , always
keeping the air outlet oriented towards the
appliance rear side. (fig. 10).
Secure it by using the screws previously re-
moved.
Blocking of the stop valve
Warning!
Before connecting the flexible exhausting
pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can
swing.
Exausting version
Connect the flange to the exhausting hole
with an appropriate pipe. Connect the ap-
pliance with the electrical mains through the
supply cord.
Filtering version
Connect the flange with a pipe suitable to
convey the air to the top of the cabinet. Con-
nect the appliance with the electrical mains
through the supply cord.
12