Filling The Tank; Selecting The Temperature - Imetec P8401 Mode D'emploi

Remove the anti-scale filter (18) from its casing.
Remove the protective red rubber pads from the anti-scale filter (18).
Insert the anti-scale filter (18) in the housing and pressing firmly into position [Fig. B].
Closes the filter flap (2).
EN
NOTE: When using the iron for the first time or whenever the filter is replaced, on
pressing the steam request button (17), a slight buzz will be heard and the iron will not
generate steam.
This is absolutely normal and is caused by the anti-scale filter filling up.
Hold the steam request button (17) pressed until the buzzing disappears and the iron begins
to deliver steam.
Sort the laundry according to the international symbols shown on the label; if this is missing, sort
according to the type of material.
Start by ironing the garments that require the lowest temperature.
WARNING! This appliance is not to be used if it has been
dropped, if there are visible signs of damage or if it is leaking
water.
WARNING! DO NOT pour diluting agents, scented liquids or
descaling agents into the reservoir as the use of these
substances can damage the product.
WARNING! DO NOT use water from dryers, air-conditioners,
water from tumble dryers, filtered water with water softeners
and rain water.
The reservoir may contain some water as each product is tested before being put on the market.

FILLING THE TANK

Check that the power supply cable with plug (7) is plugged into the socket.
Open the water fill cover (1).
Pour water into the tank (3) very slowly to avoid overflowing.
Do not exceed the maximum filling level indicated.
Close the water fill cover (1).

SELECTING THE TEMPERATURE

Plug the power supply cable with plug (7) into the socket.
Position the ON/OFF switch (5) to turn the product ON.
The steam ready light (11) comes ON to indicate that the product is heating up.
Set the temperature according to the type of fabric in line with the international symbols shown on the
labels; using the adjustment knob (13)..
The plate temperature LED (15) indicates that the iron is warming up.
Wait for the steam ready (11) LED and the plate temperature control LED (15) go off before starting
15
USE