Helios MultiZoneBox KWL-MZB Notice De Montage Et D'utilisation page 27

Installation and Operating Instructions
+
NOTE
MultiZoneBox - KWL-MZB
Ventilation level 3
"Ventilation level 3" you can enter the calculated value for intensive ventilation here.
Adjust
"Adjust..." you have the option to make a volume flow correction (within the scope of a valve calibration) in the dif-
ferent ventilation levels here.
Input difference from setpoint to actual volume flow positive or negative value in m³/h.
Duration Ventilation level 3
"Duration Ventilation level 3" Time input, whereby the set ventilation level is switched back to after its expiry (max.
240 minutes).
Sensor
Click on the "Sensor" button, this will open the following submenu.
Selection
"Selection" you can select which sensor (optional accessories) you have connected to the MZB here. A humidity
sensor or an air quality sensor (VOC + humidity) can be selected.
Sensor sensitivity
"Sensor sensitivity" for automatic operation (can only be operated after selecting a sensor) Selection between low,
medium, high.
Sensor
Humidity sensor
[% RH]
Air quality sensor
[ppm]
Service level
The "Service level" is only intended for the Helios factory service centre.
3 . Saved settings
Click on the "Saved settings" button, this will open the following submenu.
"Load from file" you can restore the saved box settings or load to an equally configurable MZB here.
"Save to file" you can save the settings for your MZB here.
We recommend saving via the function "Save to file" before any MZB firmware updates.
Stored values
Low
50
60
70
900
1200
1500
11
Fig .21
Medium High
45
40
55 50
65 60
600 500
800 700
1000 900
Fig .22
EN