Siebert S102 Série Manuel D'utilisation page 33

Features
Brillant LED display
Control BCD, BCD-packed or binary, parallel or multiplex
PLC compatible
Extended character set
Parameterization via menu
Plug-in screw terminal strip
Control of the units with 14 mm character height
This chapter is valid for unit versions S102-xx/14/0x-00x/0B-P0.
The units must be parameterized before they can be controlled. Parameterization
occurs in a menu (see Chapter 'Parameterization').
In the following, the numbers in [ ] refer to the corresponding line in the function table
at the end of this chapter.
Parallel control in the binary code
Select the setting 3 in menu item 1. The binary coded data is sent in two parts to the
inputs D7...D0 and transferred to the display with a pulse at the input DS. The higher-
15
value part (2 ...2
7 0
value part (2 ...2 ) is transferred with the falling edge of the pulse [1, 2].
The numbers are shown in the display with the falling edge of the pulse after the
higher-value and the lower-value parts have been transferred.
A sign (L = +, H = -) can be transferred with the higher-value part at input D8 [1].
If the binary value applied to the data inputs is larger than representable in the
display, (overflow) will appear in the display.
BAL S102 PAR M 1.0
8
) is transferred with the rising edge of the pulse and the lower-
33