Connecting To A Peripheral Unit - Star TSP2000 Série Mode D'emploi

3-2. Connecting to a Peripheral Unit

You can connect a peripheral unit to the printer using a modular plug. The
following describes how to install the ferrite core and make the actual connection.
See "Modular plug" on page 98 for details about the type of modular plug that is
required. Note that this printer does not come with a modular plug or wire, so it
is up to you to obtain one that suits your needs.
Important!
Make sure that the printer is turned off and unplugged from the AC outlet and
that the computer is turned off before making connections.
Ferrite core
Connector
One loop
(1) Affix the ferrite core onto the modu-
cable
– 6 –
lar wire as shown in the illustration
below.